1911ultra low slidemount for Aimpoint H1 by Jerry Keefer

Has anyone  made a copy of the  1911ultra low slide mount  for the Aimpoint  H1  that Jerry Keefer  used to make?

Dave Sams makes one. Check his website.
Jon

310yuma wrote:Has anyone  made a copy of the  1911ultra low slide mount  for the Aimpoint  H1  that Jerry Keefer  used to make?

If your talking about the one where the stock base is removed and the rail is screwed to the H1 first and then to the slide, I don't think anyone makes that.

KC does the integral cut which is the lowest I think I've seen an H1 mounted.  Much lighter too.
- Dave

From KC's FB page:

The one l saw mounted the H1 right over the ejection port and sat very low 
Thanks  l will check that web site

310yuma wrote:The one l saw mounted the H1 right over the ejection port and sat very low 
Thanks  l will check that web site

That one is a frame mount, not a slide mount, very nice!.
AimPoint MicroMount
- Dave

From Davis Sams Site:

Dave Sams is the way to go, I actually think Jerry worked on the idea with Sams. I do not know who invented it first. If you are going to do a frame mount it is expensive but it works and far less expensive than a broken frame.

this one?

Didn't Kodiak make one similar

Yes that is the one l was referring too
I guess I will have to keep looking, but l will  call David Sam's for more  info on what he has to offer

I'm pretty sure Totts made one that mounted to the Bomar rib screw pattern and then had the Aimpoint screwed on from underneath.


in fact I think I have one somewhere( and I do mean somewhere)

I made a Marvel rib with integral microdot mount out of brass after being inspired by Jerry Keefer and Fred Totts.  My goals were to get the dot as close to the bore line as possible and add some weight up front.  Took quite a bit of measuring and time on the mill but it works great.  If I were to do it again, I would change the rib to allow for extension tubes and remove more material to make it less muzzle-heavy.  Not my best photography but here goes:

Machine work done:


Right side view:


Left side view:


Shooter view:

Yes Kodiak did / does make a slide mount with an integral mounting point for an Aimpoint Micro.  I have two or three of them left in my inventory currently.