Chambers Custom Tapered Sleeve Barrel Cone
+7
SmokinNJokin
8eightring
jglenn21
Steve B
spursnguns
Jon Eulette
ASchlem
11 posters
Page 2 of 2
Page 2 of 2 • 1, 2
Chambers Custom Tapered Sleeve Barrel Cone
First topic message reminder :
I was reading older post from one of our Late Master Craftsman Jerry Keefer. He mentioned that he moved to the taper coned setup and it was in his option better. There are a few out there but are there any here in the bullseye community?
I was reading older post from one of our Late Master Craftsman Jerry Keefer. He mentioned that he moved to the taper coned setup and it was in his option better. There are a few out there but are there any here in the bullseye community?
ASchlem- Posts : 272
Join date : 2014-03-13
Location : IL
Re: Chambers Custom Tapered Sleeve Barrel Cone
Amen Brother Jon.Jon Eulette wrote:They’ll run standard BE loads. Built right guns run. Look at all the problems with typical BE pistols we see that won’t even run 4.0 BE we see on this forum with standard bushing barrels.
Jon
mine runs an 11 lb spring with 3.7 gr of E3 on a 167 gr bullet. At 3.4gr I need to go to a 10 lb spring for reliability...
10sandxs- Posts : 972
Join date : 2016-01-29
Jon Eulette likes this post
Page 2 of 2 • 1, 2
Similar topics
» Show Me Your Bullseye Pistols
» shoulder compression sleeve.
» Who has a tapered five inch
» Old Colt Cone-Front Recoil Plugs?
» Rainier Plated Truncated Cone 200gn 45ACP
» shoulder compression sleeve.
» Who has a tapered five inch
» Old Colt Cone-Front Recoil Plugs?
» Rainier Plated Truncated Cone 200gn 45ACP
Page 2 of 2
Permissions in this forum:
You cannot reply to topics in this forum