Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Proper Technique for Replacing M41 bolt pin

3 posters

Go down

Proper Technique for Replacing M41 bolt pin Empty Proper Technique for Replacing M41 bolt pin

Post by JNW1 12/2/2020, 8:41 pm

I replaced the extractor and extractor spring in my M41the other week. I don’t think it had ever been apart as I had to use a punch and some pretty good whacks from a hammer to get the bolt pin out. This caused the dimpled end to be misshapen and it would not go back in the slide. I had to file and sand that end to get it back in and it seemed fairly tight. It now backs out the left side while shooting. I have a new one ordered and want to know if there’s anything special about putting it in and out safely.
Apparently the advice from S&W is to put a little bend into the pin.
Thanks,
Jeff

JNW1

Posts : 88
Join date : 2017-12-21

Back to top Go down

Proper Technique for Replacing M41 bolt pin Empty bolt pin

Post by tyro 12/2/2020, 8:58 pm

get a new bolt pin,install pin, rest pin on vise anvil (support pin )find punch with tip to expand pin tight into slide.i tried small hammer not enough force, used larger hammer hit harder and made pin tight fit.tyro

tyro

Posts : 28
Join date : 2018-03-15
Location : livingston nj

Back to top Go down

Proper Technique for Replacing M41 bolt pin Empty Re: Proper Technique for Replacing M41 bolt pin

Post by JNW1 12/3/2020, 1:42 pm

Thanks! I can do that. Will that make it difficult to remove and replace in the future?
Jeff

JNW1

Posts : 88
Join date : 2017-12-21

Back to top Go down

Proper Technique for Replacing M41 bolt pin Empty Re: Proper Technique for Replacing M41 bolt pin

Post by -TT- 12/3/2020, 5:13 pm

Staking the end like this is a time honored approach and if done on just one side, is straightforward to remove.
-TT-
-TT-

Posts : 624
Join date : 2016-10-18

troystaten likes this post

Back to top Go down

Proper Technique for Replacing M41 bolt pin Empty Re: Proper Technique for Replacing M41 bolt pin

Post by JNW1 12/3/2020, 5:31 pm

I like time honored!

JNW1

Posts : 88
Join date : 2017-12-21

Back to top Go down

Proper Technique for Replacing M41 bolt pin Empty Re: Proper Technique for Replacing M41 bolt pin

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum