Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Source for S&W 617 extended firing pin

3 posters

Go down

Source for S&W 617 extended firing pin Empty Source for S&W 617 extended firing pin

Post by Upper40 8/19/2022, 6:17 am

Looking for a source for an extended firing pin specifically for a S&W 617-4 (22 rimfire) revolver.

Upper40

Posts : 121
Join date : 2019-09-06
Location : NY 12919

Back to top Go down

Source for S&W 617 extended firing pin Empty Re: Source for S&W 617 extended firing pin

Post by Blazin 8/20/2022, 4:26 am

My smith, Pinnacle in PA, put a centerfire extended FP in my 617 and I was not getting 100% ignition. I went back to the original FP. These 617's can be real finicky with ignition. I am unaware of an extended FP made just for the 617. Good luck!

Blazin

Posts : 47
Join date : 2022-03-18
Location : Behind enemy lines

Back to top Go down

Source for S&W 617 extended firing pin Empty 617 Firing pin

Post by shooter1450 8/20/2022, 5:25 am

I have a 617-4 that had bad problems with misfires from brand new. I just lived with it until I wanted to use it as my primary bullseye gun. Some how I figured out the firing pin was shorter than spec. Called S&W's service dept. They sent me a new one of the correct length and the misfires have pretty much disappeared. Mine was about .002" short. Don't remember the actual dimension.
shooter1450
shooter1450

Posts : 98
Join date : 2013-10-10
Age : 62
Location : Lewistown, PA

Back to top Go down

Source for S&W 617 extended firing pin Empty Re: Source for S&W 617 extended firing pin

Post by Upper40 8/20/2022, 5:45 am

shooter1450 wrote:I have a 617-4 that had bad problems with misfires from brand new. I just lived with it until I wanted to use it as my primary bullseye gun. Some how I figured out the firing pin was shorter than spec. Called S&W's service dept. They sent me a new one of the correct length and the misfires have pretty much disappeared. Mine was about .002" short. Don't remember the actual dimension.


Thanks good info...I just ordered a couple of Power Custom extended pins to experiment with. Also aware that I shouldn't dry fire with the extended pin because it could strike/damage the 617 cylinder.

Figure having the extra pins isn't a bad idea since I have a few other S&W revolvers that could potentially use them.

Upper40

Posts : 121
Join date : 2019-09-06
Location : NY 12919

Back to top Go down

Source for S&W 617 extended firing pin Empty Re: Source for S&W 617 extended firing pin

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum