Nelson Conversion chamber cleaing
3 posters
Page 1 of 1
Nelson Conversion chamber cleaing
How do you clean the chamber on the Nelson 22 conversion?, when I try to get my cleaning rod in it hits the ejector and I don't want to take a chance on bending it!
Deerspy- Posts : 246
Join date : 2013-01-30
Location : east Iowa
Re: Nelson Conversion chamber cleaing
try bending a 25 cal, rifle brass brush in the shape of a L to the camber length then insert from breach, works on all my 22s
DavidR- Admin
- Posts : 3032
Join date : 2011-06-10
Age : 70
Location : NRA:Expert, Georgia
Re: Nelson Conversion chamber cleaing
thanks DavidR, I will try that, I might use a nylon L shaped, I wonder if there is a flexible one like a snake that might work also.
Deerspy- Posts : 246
Join date : 2013-01-30
Location : east Iowa
Re: Nelson Conversion chamber cleaing
Nylon not tough enough to clean the carbon from the chamber, I tried that, bad results. Good copper to cut the carbon, the evil that causes the problem.
Re: Nelson Conversion chamber cleaing
bronze or brass does the job, wont hurt a thing, I'm not a fan of bore snakes, the reason u bend a long one to just as long as a fired case is so you fit it to the chamber length only and don't get into the rifling's.Deerspy wrote:thanks DavidR, I will try that, I might use a nylon L shaped, I wonder if there is a flexible one like a snake that might work also.
DavidR- Admin
- Posts : 3032
Join date : 2011-06-10
Age : 70
Location : NRA:Expert, Georgia
Similar topics
» What chamber to order for Nelson or Marvel, standard or Bullseye
» Nelson Conversion Bullseye Chamber?
» Kart 22 LR conversion chamber repair?
» marvel conversion vs nelson conversion
» DICK HORTON MATCH GRIPS - NEW E-MAIL ADDRESS
» Nelson Conversion Bullseye Chamber?
» Kart 22 LR conversion chamber repair?
» marvel conversion vs nelson conversion
» DICK HORTON MATCH GRIPS - NEW E-MAIL ADDRESS
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum