Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Bullseye-L Forum

A Forum dedicated to the sport of Bullseye shooting


I need a little help.....

3 posters

Bullseye-L Forum :: Equipment Discussion

Go down

I need a little help..... Empty I need a little help.....

Post by Multiracer 12/30/2017, 7:50 pm

Someone who has a 1" Ultradot. Can you please give me a measurement of the ID of the rubber eye relief  cyclops  that comes with the unit ?
I switched to 30 mm and sold my 1" stuff.

Thanks
Ron

Multiracer

Posts : 1003
Join date : 2017-03-15
Location : North Ohio

Back to top Go down

I need a little help..... Empty Re: I need a little help.....

Post by Plunker 12/30/2017, 8:23 pm

Ron,

O.D. of the fit area of the 1" scope is .915 Dia.  I don't have an actual rubber boot to measure .  Hopefully this helps you.
  
Regards
Plunker

Plunker

Posts : 112
Join date : 2017-10-11
Location : N.C.

Back to top Go down

I need a little help..... Empty Re: I need a little help.....

Post by Boxturtle 12/31/2017, 6:53 am

The rubber, truncated cone ID measurements are approximately 0.95" and 1.30".  The length of the object is 1.10".  The measurements are approximate because the object is quite flexible.  The one I measured is unused and has not been stretched.

Boxturtle

Posts : 244
Join date : 2017-09-15
Location : Virginia

Back to top Go down

I need a little help..... Empty Re: I need a little help.....

Post by Multiracer 12/31/2017, 9:42 am

Cool, Thank you guys.

Multiracer

Posts : 1003
Join date : 2017-03-15
Location : North Ohio

Back to top Go down

I need a little help..... Empty Re: I need a little help.....

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

Bullseye-L Forum :: Equipment Discussion

 
Permissions in this forum:
You cannot reply to topics in this forum