Dan Wesson slide dovetails
3 posters
Page 1 of 1
Dan Wesson slide dovetails
I've got 5 DW 1911's and am wanting to put other sights on some of the guns. I'm under the impression that DW uses a Novak dovetail on their slides. However, I visited the Novak site and they have DW on their list of unapproved users of their design. Has anyone replaced the rear and/or front sights on DW guns and had any issues with sights or RMR mounting plates fitting properly? I've emailed DW but haven't had a response yet.
adamsgt- Posts : 8
Join date : 2018-01-20
Age : 84
Location : Fort Worth Texas
Re: Dan Wesson slide dovetails
You can call DW. Some used Novak and some used Bomar cut.
The folks at Brownells will know if you call them also. The first two digits of the serial number are the year of mfg.
David
The folks at Brownells will know if you call them also. The first two digits of the serial number are the year of mfg.
David
David R- Posts : 408
Join date : 2018-12-10
Age : 64
Location : Hamlin NY
Re: Dan Wesson slide dovetails
You'll have to use a "knock off" Novak sight if you replace the ones on your DW. Kensight should be a direct replacement fit.
Thanks for the info
Look like I'll have to do a little more digging to end up with the correct sights. David, appreciate the info on the DW serial numbers. Kc thanks for pointing me to Kensight, got them bookmarked now.
adamsgt- Posts : 8
Join date : 2018-01-20
Age : 84
Location : Fort Worth Texas
Similar topics
» smith wesson 52 slide to frame fitting
» Dan Wesson for a BE Gun?
» Smith & Wesson
» Smith and Wesson 52-2
» Dan Wesson PM 45 good enough?
» Dan Wesson for a BE Gun?
» Smith & Wesson
» Smith and Wesson 52-2
» Dan Wesson PM 45 good enough?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum