Testing a MatchGuns MG4 barrel
2 posters
Page 1 of 1
Testing a MatchGuns MG4 barrel
Greetings,
I was offered the opportunity to test a MatchGuns MG4 32 S&W Long WadCutter barrel.
Of course, I welcomed the offer!!!
The barrel is about 152mm long. The groove diameter is 0.3148", bore diameter 0.3035", with six lands and grooves. I did not measure the twist.
The chamber measures 0.339" at the front and 0.3425" at the rear.
All groups fired at 50 yards with the barrel held in a mechanical fixture.
Cheers,
Dave
I was offered the opportunity to test a MatchGuns MG4 32 S&W Long WadCutter barrel.
Of course, I welcomed the offer!!!
The barrel is about 152mm long. The groove diameter is 0.3148", bore diameter 0.3035", with six lands and grooves. I did not measure the twist.
The chamber measures 0.339" at the front and 0.3425" at the rear.
All groups fired at 50 yards with the barrel held in a mechanical fixture.
Cheers,
Dave
Last edited by fc60 on 6/2/2019, 3:22 pm; edited 2 times in total (Reason for editing : Image Errors)
fc60- Posts : 1458
Join date : 2011-06-11
Location : South Prairie, WA 98385
Re: Testing a MatchGuns MG4 barrel
Wow, very interesting. The barrel diameter is significantly larger than what the MG specs indicate as I recall? However, the results are impressive. Even the Splinkers are ok. I use them for 25y often, when too lazy to bump them.
gregbenner- Posts : 738
Join date : 2016-10-29
Location : San Diego area
Similar topics
» Testing The Pardini 32 ACP Off The Shelf Barrel
» Barrel Testing Fixture Question
» Actual barrel diameter Matchguns MG-4 and Pardini HP32
» ECI for a Matchguns
» Matchguns MG2
» Barrel Testing Fixture Question
» Actual barrel diameter Matchguns MG-4 and Pardini HP32
» ECI for a Matchguns
» Matchguns MG2
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum