Flywheel bullet sizer
Page 1 of 1
Flywheel bullet sizer
For those of you shooting coated projectiles, I built a "flywheel" bullet sizer. The crank arm is (now) a 1.5" square tube filled with lead. The sizer die block needs to be welded on yet, but you get the point. Effort to run the crank is almost zero. Effortless sizing as fast as you can feed bullets into the sizing "magazine"
You can see it in action here...
https://youtu.be/ZeNVsa9VmRk
https://youtu.be/isMNFwNgCk8
You can see it in action here...
https://youtu.be/ZeNVsa9VmRk
https://youtu.be/isMNFwNgCk8
10sandxs- Posts : 972
Join date : 2016-01-29
Similar topics
» cast bullet luber sizer
» A question for those that use a Star sizer/lubricator
» .45 shells bullet up or bullet down in box?
» Tumble Lube versus Lube Sizer
» 185 or 200 Gr .45 ACP bullet?
» A question for those that use a Star sizer/lubricator
» .45 shells bullet up or bullet down in box?
» Tumble Lube versus Lube Sizer
» 185 or 200 Gr .45 ACP bullet?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum