Bullseye-L Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Larry's Trailside trigger kit drill and tap size?

4 posters

Go down

Larry's Trailside trigger kit drill and tap size? Empty Larry's Trailside trigger kit drill and tap size?

Post by Dtdk 1/27/2020, 8:33 pm

I plan on ordering a couple of these kits from Jim Henderson.  However he does not have any kits with the drill bit and tap.  So does anyone know what size I need to have to install it?

Dtdk

Posts : 31
Join date : 2020-01-03

Back to top Go down

Larry's Trailside trigger kit drill and tap size? Empty Re: Larry's Trailside trigger kit drill and tap size?

Post by jglenn21 1/28/2020, 9:17 am

I personally haven't found the set screw neccessary. I used purple 222 locktite on the screw that controls the second stage and trigger stop. It's been fine for well over a year on two pistols.. once you the screw adjusted you simply need it to stay put. I'll check today to see if i have the screw.from an old kit
jglenn21
jglenn21

Posts : 2620
Join date : 2015-04-07
Age : 76
Location : monroe , ga

Back to top Go down

Larry's Trailside trigger kit drill and tap size? Empty Re: Larry's Trailside trigger kit drill and tap size?

Post by DavidR 1/28/2020, 3:59 pm

I have the drill and tap set looks like it says 0.50 Larry's Trailside trigger kit drill and tap size? Img_7410
Larry's Trailside trigger kit drill and tap size? Img_7411


Last edited by DavidR on 1/29/2020, 3:42 pm; edited 2 times in total
DavidR
DavidR
Admin

Posts : 3032
Join date : 2011-06-10
Age : 70
Location : NRA:Expert, Georgia

Back to top Go down

Larry's Trailside trigger kit drill and tap size? Empty Re: Larry's Trailside trigger kit drill and tap size?

Post by jglenn21 1/28/2020, 4:46 pm

That tap looks correct. The screws i had left.over were 3mm..
jglenn21
jglenn21

Posts : 2620
Join date : 2015-04-07
Age : 76
Location : monroe , ga

Back to top Go down

Larry's Trailside trigger kit drill and tap size? Empty Re: Larry's Trailside trigger kit drill and tap size?

Post by rreid 1/28/2020, 7:42 pm

If I recall, the frame on my Trailside was very hard. If there was a way to do it without the drilling and tapping, I'd look into it.
rreid
rreid

Posts : 562
Join date : 2012-02-06

Back to top Go down

Larry's Trailside trigger kit drill and tap size? Empty Re: Larry's Trailside trigger kit drill and tap size?

Post by jglenn21 1/28/2020, 8:26 pm

yes they are hard and that's a small drill and tap..
jglenn21
jglenn21

Posts : 2620
Join date : 2015-04-07
Age : 76
Location : monroe , ga

Back to top Go down

Larry's Trailside trigger kit drill and tap size? Empty Re: Larry's Trailside trigger kit drill and tap size?

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum