Weaver 62 Rail/EIC
2 posters
Page 1 of 1
Weaver 62 Rail/EIC
When and if I ever get to shoot my first EIC match must I remove my weaver 62 rail from my model 41?
xman- Posts : 497
Join date : 2015-01-11
Age : 69
Location : Tyler,TX
Re: Weaver 62 Rail/EIC
"Pistols used in CMP-Sanctioned 22 Rimfire National Trophy and EIC Pistol
Matches must comply with this rule. The following rules apply to these pistols:
a) The pistol may be either a semi-automatic pistol or a revolver.
b) The pistol must be chambered for .22 cal. rimfire long rifle cartridges.
c) The pistol may have asymmetrical, orthopedic or specially shaped grips.
d) The pistol may have only open sights. Optical sights are not permitted.
The rear sight may be adjustable, but must have an open “U” or
rectangular notch. Adjustable front sights are permitted, but extended
39
front sights are not permitted. The total sight radius may not be more than
10.0 inches as measured from the rear surface of the rear sight to the
highest point of the front sight.
e) The pistol must have a trigger pull of at least 2.0 pounds.
f) Any system of recoil control based on barrel venting, barrel porting or other
similar recoil reduction system is prohibited."
So no problem. I have a Ruger MKIV and I'm planning on leaving the Weaver rail fixed to the barrel.
Matches must comply with this rule. The following rules apply to these pistols:
a) The pistol may be either a semi-automatic pistol or a revolver.
b) The pistol must be chambered for .22 cal. rimfire long rifle cartridges.
c) The pistol may have asymmetrical, orthopedic or specially shaped grips.
d) The pistol may have only open sights. Optical sights are not permitted.
The rear sight may be adjustable, but must have an open “U” or
rectangular notch. Adjustable front sights are permitted, but extended
39
front sights are not permitted. The total sight radius may not be more than
10.0 inches as measured from the rear surface of the rear sight to the
highest point of the front sight.
e) The pistol must have a trigger pull of at least 2.0 pounds.
f) Any system of recoil control based on barrel venting, barrel porting or other
similar recoil reduction system is prohibited."
So no problem. I have a Ruger MKIV and I'm planning on leaving the Weaver rail fixed to the barrel.
tovaert- Posts : 455
Join date : 2018-11-28
Similar topics
» Dot re-zero after removal and re-installation
» quick release mount for aimpoint H2 weaver rail
» Hawke Sport Optics Vantage 1x30 Red Dot Sight w/ Weaver Rail 12104
» Pic/Weaver rail with dovetail to fit the S&W 41's with the extendable front sight barrel channel without drilling
» Weaver Vs Picatinney
» quick release mount for aimpoint H2 weaver rail
» Hawke Sport Optics Vantage 1x30 Red Dot Sight w/ Weaver Rail 12104
» Pic/Weaver rail with dovetail to fit the S&W 41's with the extendable front sight barrel channel without drilling
» Weaver Vs Picatinney
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum