O Rings for SP Bolt
2 posters
Page 1 of 1
O Rings for SP Bolt
I bought some o rings when a thread came up about them a while back. I decided to check mine. I measured the existing ones at .064" thick. The new ones are .070". The existing look fine, no discoloration or degradation. Gun still shoots reliably. I had to compress a decent amount to get the drift pin back in. With the new ones it would be like having an extra o ring by comparison. Any advice would be great.
Bill
Bill
messenger- Posts : 1035
Join date : 2011-06-18
Location : North Carolina
Re: O Rings for SP Bolt
When I replaced mine it was hard to push the plug in to allow the press pin to go in.
James Hensler- Posts : 1245
Join date : 2018-01-15
Age : 55
Location : Southwest Florida
Similar topics
» Pardini bolt o-rings
» MatchDot II rings vs. LCI mounting rings 30 mm
» Proper Technique for Replacing M41 bolt pin
» Bolt pin for a Model 41
» S&W Model 41 Bolt Replacement
» MatchDot II rings vs. LCI mounting rings 30 mm
» Proper Technique for Replacing M41 bolt pin
» Bolt pin for a Model 41
» S&W Model 41 Bolt Replacement
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum