LPA rear sight pin broken
3 posters
Page 1 of 1
LPA rear sight pin broken
The LPA rear sight on my Springfield "loaded" 45 has a broken hinge pin. I bought one from Kensight but the diameter was too large. It was .078" my pin is .076. LPA doesn't sell parts, none have another Source?
Thanks / Chet
Thanks / Chet
stratshtr- Posts : 2
Join date : 2022-11-09
Re: LPA rear sight pin broken
Buy a drill bit in correct diameter and cut the shank to proper length and your good to go.
Jon
Jon
Jon Eulette- Posts : 4399
Join date : 2013-04-15
Location : Southern Kalifornia
RoyDean likes this post
Re: LPA rear sight pin broken
Yep, that's precisely a #48. Use two pairs of pliers nose-to-nose to snap the shank, then finish the length on the grinder.
-TT-- Posts : 624
Join date : 2016-10-18
Similar topics
» Smith and Wesson Model 41 rear sight blade is all the way left - need to center entire rear sight assembly
» S & W rear sight vs. Keng rear sights
» What is the Optimal Ratio Between Rear Sight Opening and Front Sight Width????
» What are your front sight blade and rear sight "notch" dimensions for your 1911 EIC/CMP hardball competition pistol?
» Rear Sight Leaf Pin Gold Cup NM 70 series ( Elliason sight)
» S & W rear sight vs. Keng rear sights
» What is the Optimal Ratio Between Rear Sight Opening and Front Sight Width????
» What are your front sight blade and rear sight "notch" dimensions for your 1911 EIC/CMP hardball competition pistol?
» Rear Sight Leaf Pin Gold Cup NM 70 series ( Elliason sight)
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|