Marvel Extractor crack
5 posters
Page 1 of 1
Marvel Extractor crack
Is there suppose to be crack in the extractor hole where the roll pin goes through
it looks like a clean cut perfectly centered with the hole
it looks like a clean cut perfectly centered with the hole
45 MIKE- Posts : 65
Join date : 2012-08-27
Location : SHEBOYGAN, WI
Re: Marvel Extractor crack
It's not a crack,it's where the EDM wire enters to cut the hole,part of the process.
Bubba Blaster- Posts : 187
Join date : 2013-10-20
Re: Marvel Extractor crack
Did you happen to borrow Marion Barry's Marvel?
john bickar- Posts : 2280
Join date : 2011-07-09
Age : 100
Location : Menlo Park, CA
Re: Marvel Extractor crack
Maybe Rob Ford's Marvel?
BE Mike- Posts : 2590
Join date : 2011-07-29
Location : Indiana
Re: Marvel Extractor crack
Cracks are not uncommon on the left side of the slide at the 90 degree cut and where the extractor wears into the chamber bore.
Coincidentally, Marion Berries make excellent pies.
Coincidentally, Marion Berries make excellent pies.
Larry Lang- Posts : 198
Join date : 2011-06-10
Age : 84
Location : Frederickson, WA
Re: Marvel Extractor crack
Bubba Blaster wrote:It's not a crack,it's where the EDM wire enters to cut the hole,part of the process.
Just talked to the folks at Marvel and they said the same thing
45 MIKE- Posts : 65
Join date : 2012-08-27
Location : SHEBOYGAN, WI
Similar topics
» Older, thin extractor Marvel conversion
» For my BAIKAL IZH35M I need extractor, extractor plunger, extractor spring. Please help!!
» Volquartsen extractor vs Standard Extractor
» proper 45 wad gun ejector
» Hammerli 208s vs marvel conversion
» For my BAIKAL IZH35M I need extractor, extractor plunger, extractor spring. Please help!!
» Volquartsen extractor vs Standard Extractor
» proper 45 wad gun ejector
» Hammerli 208s vs marvel conversion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum