Clark Custom M41 Barrels
5 posters
Page 1 of 1
Clark Custom M41 Barrels
Any of you guys shoot these? Any accuracy feedback to offer? Any reason to go for the extension back over the slide for the models set up for scope?
Axehandle- Posts : 879
Join date : 2013-09-17
Location : Alabama
Re: Clark Custom M41 Barrels
Excellent barrel with under 1" accuracy at 50 yds. The extension over the slide provides a balance which is not barrel-heavy.
172snowhawk- Posts : 28
Join date : 2014-03-24
Re: Clark Custom M41 Barrels
When I had my M41 installed the barrel without the strap over the slide to get rid of trapped cases upon ejection that I was having problems with in the stock barrel.
Mounted my Ultradot with two rings on the front end and let it hang back over the ejection port.
No more trapped cases= no more alibis since I owned it.
Shot some of my best scores with that barrel.
Mounted my Ultradot with two rings on the front end and let it hang back over the ejection port.
No more trapped cases= no more alibis since I owned it.
Shot some of my best scores with that barrel.
C.Perkins- Posts : 742
Join date : 2011-06-13
Age : 61
Location : Surrounded by pines in Wi.
Re: Clark Custom M41 Barrels
+1 on this setup almost eliminating stove pipe jams on the M41.
Very accurate barrel. I found it to be a very tight chamber and have to keep it clean to keep it functioning.
I like the balance w/o the extension over the chamber.
Very accurate barrel. I found it to be a very tight chamber and have to keep it clean to keep it functioning.
I like the balance w/o the extension over the chamber.
gulliver62- Posts : 106
Join date : 2011-10-27
Location : Atlanta, GA
Re: Clark Custom M41 Barrels
I have the no-extension model and I have found it to be accurate and reliable with CCI Standard Velocity. It even suffered a dinged chamber when the firing pin broke in half a few years ago. I bought a chamber ironing tool from Brownells, made the repair, and it's been fine ever since. By the way, what appears to be a Weaver-style groove towards the rear of the extension-equipped model is, according to Clark, more decoration than anything else. They claim it's too shallow for most Weaver rings, in case you were thinking of using that groove to position the scope more towards the back.
John McCormick- Posts : 177
Join date : 2014-06-25
Location : SW FL
Re: Clark Custom M41 Barrels
Good deal.. Thanks for the input guys. With no rear sight to mount I didn't see a lot of reason for the extension over the slide.
Axehandle- Posts : 879
Join date : 2013-09-17
Location : Alabama
Similar topics
» S&W 52 barrels by Clark
» Clark 52 barrels
» Clark's M52 Barrels - who has one?
» Clark Model 52 1:10 Barrels
» Custom Walther gSP barrels?
» Clark 52 barrels
» Clark's M52 Barrels - who has one?
» Clark Model 52 1:10 Barrels
» Custom Walther gSP barrels?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum