Ring pull to retract bridged Citation/Victor slides

Elsewhere there has been mentioned of a sort of ring pull slide racker that's available (Tandemkoss) for the Model 41 s&w.

Such a gizmo sure would help retract the bridged slideson Citations or Victors 

Is anyone aware of such an aid as this that's available for High Standards?

www.interarmstx.com/product/cocking-handle-for-all-models/

This is not a ring pull device but might be worth investigating. The only drawback I see is that the slide needs to have a hole drilled into it.

A 3/4" shoulder bolt works just fine. Think i used a 6-32
 Mine is located on the right front side.

Ruby Fox shot a Bob Chow HS that had a screw on each side of the rear of the slide. The screws were blued to match the slide. It was really a beautifully built pistol.
Jon

Custom HS racker.

https://www.bullseyeforum.net/t6759-high-standard-slide-racker

jglenn21,

If it isn't much trouble can you post a photovraph?  Especially the detail location of the screw hole?

Thank you.

Jon Eulette wrote:Ruby Fox shot a Bob Chow HS that had a screw on each side of the rear of the slide. The screws were blued to match the slide. It was really a beautifully built pistol.
Jon

Ahh, THAT"S what those screws are for!

Here's mine.. sorry for al the grease. you can see it's placed right above the extractor.. my wife shot this gun with an LSP barrel and dot on it so the placement was needed there.

BTW if you ever decide to remove the rear bridge mount think of it as permanently off... nightmare to put one back on.