GSG 1911 .22 magazine
+2
Olde Pilot
OldShooter43
6 posters
Page 1 of 1
GSG 1911 .22 magazine
This magazine is made by Hersteller German Sport Guns Gmbh and seems very well built. It has two loading knobs, one for 5 rounds and one for 10 rounds. I inserted it in my Les Baer target pistol that I have a Nelson conversion mounted on, and it fits fine - with a little nudge to get past the mag release. I haven't had a chance to try it out yet but hope that someone here might have some experience with these mags. Any thoughts or comments would be appreciated.
Jim
Jim
OldShooter43- Posts : 244
Join date : 2018-05-19
Location : Williamsburg, VA
Re: GSG 1911 .22 magazine
Work great. If doesn't, will probably be mag catch too high or too low.
Olde Pilot- Posts : 315
Join date : 2015-07-27
Location : Apopka Fl (Central Fl)
Re: GSG 1911 .22 magazine
I have a couple and they work ok on all of my frames except for my Led Baer. It fell out every time I shot it. There is a ridge running up the back of the mag that stops about an inch shy of the top. I made an aluminum spacer and glued it on. Now it works fine. I will try to post a picture.
gregg28- Posts : 23
Join date : 2015-12-27
Re: GSG 1911 .22 magazine
OK. My mag body is unblued but the rib steps down about 1/16" about where your spacer starts. I need to do a side by side comparison with the Nelson mags to see how they differ. I don't have my "workshop" anymore so making a spacer may be a challenge. However, where there's a will there's a way!
Thanks again.
Thanks again.
OldShooter43- Posts : 244
Join date : 2018-05-19
Location : Williamsburg, VA
Re: GSG 1911 .22 magazine
you can get magazine shims from Travis at Marvel Precision
they're pre-cut & have pressure sensitive tape to hold them in place
they're pre-cut & have pressure sensitive tape to hold them in place
STEVE SAMELAK- Posts : 958
Join date : 2011-06-10
Re: GSG 1911 .22 magazine
OK, Steve. I'll definitely check that out. Thank you for the info.
Jim
Jim
OldShooter43- Posts : 244
Join date : 2018-05-19
Location : Williamsburg, VA
Re: GSG 1911 .22 magazine
Interesting day at the range today. I took the GSG .22 magazine along with my Nelson mags to see what would happen. Surprise, surprise. The GSG magazine worked fine in my Les Baer CMP pistol. I ran two mag loads with 5 rounds and two mag loads with 10 rounds with no problems whatsoever. I shot the first mag load kneeling in case the mag dropped out when I fired. It didn't happen. Maybe I'm just lucky. I'll probably check on the shims at Marvel just in case my luck runs out. :0)
OldShooter43- Posts : 244
Join date : 2018-05-19
Location : Williamsburg, VA
Re: GSG 1911 .22 magazine
I have a Nelson on a SA Mil Spec and it runs with Nelson mags and GSG mags. However,
the Nelson mags do not run in the GSG.
the Nelson mags do not run in the GSG.
kidneyboy- Posts : 69
Join date : 2018-09-06
Re: GSG 1911 .22 magazine
I had to file a little bit on the left hand side upper lip of the GSG so that it would slide in smoother. All of 5 minutes for 5 magazines. Now they go in very smoothly.
Joel
Joel
1joel1- Posts : 401
Join date : 2012-11-09
Location : San Diego, CA
Similar topics
» 1911 magazine fit
» 1911 .45 magazine
» 1911 Magazine Question
» 1911 Magazine Springs
» 1911 Magazine springs, check yours
» 1911 .45 magazine
» 1911 Magazine Question
» 1911 Magazine Springs
» 1911 Magazine springs, check yours
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum