KC Battle Axe in Mil Spec?

Does anyone have a picture of what the KC Battle Axe hammer would look like in a 1911 with the Mil Spec grip safety? The website says it'll fit. I was wondering what that would look like. If you have this kind of set up please share a picture. Thanks!

I have it in a Range Officer, so I can't help.

Who still uses gi grip safeties...? that's so 2014....

My 1980s ball gun with welded up Colt Barrel does, but no Battle AX in it.

If your talking about the original Battle Ax, the one that looks like an AX it may fit but will bite you like the original service pistol hammers did. Probably work good with a Beaver Tail safety but with out the protection your web will get chewed on.

Frank, the Battle Axe WILL NOT bite the hand that shoots it.  Spur is rather short to ensure that doesn't happen.

I stand corrected by da man that knows, I was looking at the photos.

I know this has been asked and answered but I still want to throw my 2 cents in. If you have ever tried to use a Mil-spec hammer in a Beavertail then you probably found out they don't fit. The spur is too long. The Battle Ax will fit in the Beavertail because its spur is shorter then a mil-spec spur. Ergo, it will work fine.

Len

I have two they work fine and look cool.

Well thank you very much for all your responses especially for KC weighing in here with the definitive answer. Thanks! Reason I ask is I'm soon to have a wad gun built on a Mil Spec and I'm considering the KC kit and like the look of the Axe. Thanks again.

Jason, it will work perfectly.